Windows: Active Response Configuration

To start, you need to enable active response on Windows (disabled by default). To do that, just add the following to the agent’s ossec.conf:

<active-response>
    <disabled>no</disabled>
</active-response>

After that, you need to go to the manager and specify when to run the response. Adding the following to ossec.conf will enable the responses for alerts above level 6:

<command>
    <name>win_nullroute</name>
    <executable>route-null.cmd</executable>
    <expect>srcip</expect>
    <timeout_allowed>yes</timeout_allowed>
</command>

<active-response>
    <command>win_nullroute</command>
    <location>local</location>
    <level>6</level>
    <timeout>600</timeout>
</active-response>

With the configuration completed (and the manager restarted), you can test the active response by running the agent-control script (in this case, I am running it on agent id 185 to block ip 2.3.4.5):

# /var/ossec/bin/agent_control -L

OSSEC HIDS agent_control. Available active responses:

Response name: host-deny600, command: host-deny.sh
Response name: firewall-drop600, command: firewall-drop.sh
Response name: win_nullroute600, command: route-null.cmd

# /var/ossec/bin/agent_control -b 2.3.4.5 -f win_nullroute600 -u 185

OSSEC HIDS agent_control: Running active response "win_nullroute600′ "n: 185

And looking at the agent you should see the new entry in the route table:

C:\>route print
..
Active Routes:
Network Destination Netmask Gateway Interface Metric
2.3.4.5 255.255.255.255 x.y.z x.y.z 1
..

If you run into any issues, look at the ossec.log file (on the agent) for any entry for ossec-execd. If you enabled it correctly, you will see:

2008/08/20 11:53:49 ossec-execd: INFO: Started (pid: 3896).

Previous topic

UNIX: Active Response Configuration

Next topic

Understanding Active Response with FreeBSD